Crestron CHV-TSTATEX Guia de Instalação descarregar pdf (Página 70)

Thermostats Crestron CHV-TSTAT and CHV-THSTAT

•

Thermostats: CHV-TSTAT and CHV-THSTAT Operations and Installation Guide – DOC. 8163E

View Button Menus

Pressing the VIEW button allows the user to access the following screens:

NOTE: If enabled, the VIEW button also allows access to the remote button function screens. When

part of a Cresnet system, the up ▲ and down ▼ arrow buttons can be used to enable other functions

(i.e., lighting control, alarm system, etc).

“Humidity” Screen

MODE

VIEW



Humidity

Press the VIEW button to display the “Humidity” screen.

The setpoint adjustment range is 5 – 90%.

Use the up ▲and down ▼arrow buttons to adjust the

humidity setpoint level.

NOTE: This page only appears if enabled in the “HUM

OPTS” setup screen.

NOTE: CHV-TSTAT requires additional remote humidity

sensor (CHV-RTHS, sold separately).

NOTE: If a CHV-RTHS temperature/humidity sensor is

installed, a CHV-TSTAT can import and display the

humidity.

“Outdoor” Screen

MODE

VIEW



Outdoor

Press the VIEW button again to display the “Outdoor”

screen. This allows the user to view the outdoor

temperature (if an outdoor sensor has been installed) and

outdoor humidity (if available). Outdoor

temperature/humidity can come from an outdoor sensor

wired directly to the thermostat or through the Cresnet

system from another source. This page is only displayed if

enabled in the “SCRN OPTIONS” setup screen.

NOTE: This is only a display and not for system

activation. This display can be shown on either the

CHV-TSTAT or the CHV-THSTAT.

“Messages” Screen

MODE

VIEW



Messages

Emergency Gen in Use

<CLR

Press the VIEW button again to display the “Messages”

screen. This screen allows the user to view any text

messages sent from the control system (only when part of a

Cresnet system). Text messages are limited to four lines,

approximately 20 characters per line (including spaces).

Allow for word wrap by staying within the 20

characters/spaces per line maximum. The thermostat

auto-hyphenates when nearing the end of a line. Carriage

returns can be used to force a line change.

NOTE: This page is only seen when a message has been

sent to the thermostat.

Press the MODE button to clear (CLR) the message(s).

This acknowledges to the control system that the message

has been read.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 91 92

Comentários a estes Manuais

Sem comentários

Crestron CHV-TSTATEX Guia de Instalação Página 70

Comentários a estes Manuais

Manuais e produtos relacionados com Termóestatos Crestron CHV-TSTATEX