Crestron CHV-TSTATEX Guia de Instalação descarregar pdf (Página 28)

Thermostats Crestron CHV-TSTAT and CHV-THSTAT

•

Thermostats: CHV-TSTAT and CHV-THSTAT Operations and Installation Guide – DOC. 8163E

Installation

The location of the thermostat can affect its performance and efficiency. Install the

thermostat away from direct sunlight, drafts, doorways, skylights, and windows.

Also make sure the thermostat is conveniently located for programming, and do not

mount on an exterior wall. The thermostats may be mounted directly to drywall or to

a 1-gang box.

Thermostats and sensors are mounted 60 inches (~1.6 meters) above the finished

floor (HVAC industry standard).

The following tools and hardware are required for installation.

• Phillips screwdriver (not supplied)

• Two 6-32 x 1-inch panhead screws (included) for mounting to a 1-gang box

• 1-gang electrical box (not supplied)

• Wall anchors (not supplied) and screws (not supplied) for mounting directly

to drywall

Refer to the following illustrations and use the following procedure to install the

CHV-TSTAT or the CHV-THSTAT.

NOTE: When installing directly on drywall, use anchoring screws and hardware.

Make sure the back of the thermostat is flush with drywall and the unit is level.

NOTE: If replacing an existing thermostat, make note of the wire colors and

positions before removing the old thermostat.

1. Separate thermostat front plate from back plate (it may be necessary to exert

force when removing the faceplate).

2. Turn off the circuit breaker when connecting power to the thermostat, and

connect wiring as required (wiring goes through center hole on back plate).

NOTE: Ensure the correct position of the P4 jumper; refer to pages 11

through 20.

3. Attach back plate to drywall with screws and anchors (anchor hardware not

supplied) 60 inches (~1.6 meters) above the finished floor. Thermostat may

also be mounted to a 1-gang electrical box, horizontally mounted, using the

two included 6-32 x 1 inch panhead screws. If using a 5-sided

1-gang electrical box, fill with insulation material to minimize wall air

ingress. Ensure that the thermostat is level and the ventilation holes in the

backplate are not blocked.

4. Note orientation of front plate connection leads and reattach the front plate

to the back plate (make sure front plate snaps in place and no wires are

pinched).

CAUTION: Do not press on the LCD display during installation, as this

may cause the screen to crack.

5. Carefully remove the warning label from the LCD display.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 91 92

Sem comentários

Crestron CHV-TSTATEX Guia de Instalação Página 28