Crestron STRFGWX Especificações descarregar pdf (Página 32)

2-Way RF Wireless Touchpanel Crestron STX-1700C

Appendix A: Engraveable Pushbutton Installation

Custom-engraved pushbuttons can be obtained by ordering the Customizable

Engraving Button Kit 1700C-BTBN. You can submit the engraving layout in two

ways:

• Engraving Sheet, Doc. 6069.

• Engraving Software package, Version 1.1.1.6, available from the

Downloads | Software Updates section of the Crestron website

(www.crestron.com

Perform the following to install engraveable pushbuttons on the ST-1700C. A #1

Phillips screwdriver is required. Refer to the illustrations below.

1. Remove the battery, and place the touchpanel face down on a clean work

surface.

2. Remove the four screws securing the front bezel to the base, and return the

unit to its normal position (use care to prevent the bezel from dropping and

becoming damaged).

3. Lift the bezel from the touchpanel, and remove the pushbuttons being

replaced. Note that the pushbutton sets fit snugly.

4. Put the new pushbuttons in place (see following Note), press firmly to

ensure they are seated, and place the bezel back in position.

NOTE: The rear of the pushbuttons are marked TOP 1-5 and 6-10 to ensure correct

orientation when installed. Do not remove the plastic frame connecting the buttons

together.

5. Hold the bezel in place and turn the unit over on its face.

6. Reinstall the four screws to secure the bezel to the base. Tighten the screws,

being careful not to strip the threads.

7. Reinstall the battery and verify that the pushbuttons function properly.

Engraveable Pushbutton Installation Diagram

Battery

ScrewScrew

Bezel

Pushbuttons

Bottom view

Top view with

bezel removed

• 2-Way RF Wireless Touchpanel: STX-1700C Operations Guide - DOC. 6049

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 38 39 40

Sem comentários

Crestron STRFGWX Especificações Página 32