Crestron CT-1550 Especificações descarregar pdf (Página 10)

Wired 5.7 Inch Tabletop Touchpanel Crestron CT-1550

6 • Wired 5.7 Inch Tabletop Touchpanel: CT-1550 Operations Guide – DOC. 6116A

Wire Gauge Values

RESISTANCE (R) WIRE GAUGE

Doubled CAT5

8.7

Tripled CAT5

NOTE: All network wiring must consist of two twisted pairs. One twisted pair is

the +24V conductor and the GND conductor, and the other twisted pair is the Y

conductor and the Z conductor.

NOTE: When daisy-chaining Cresnet units, strip the ends of the wires carefully to

avoid nicking the conductors. Twist together the ends of the wires that share a pin on

the network connector, and tin the twisted connection. Apply solder only to the ends

of the twisted wires. Avoid tinning too far up the wires or the end becomes brittle.

Insert the tinned connection into the Cresnet connector and tighten the retaining

screw. Repeat the procedure for the other three conductors.

NOTE: For larger networks (i.e., greater than 28 network devices), it may be

necessary to add a Cresnet Hub/Repeater (CNXHUB) to maintain signal quality

throughout the network. Also, for networks with lengthy cable runs, it may be

desirable to add a hub/repeater after only 20 network devices.

Identity Code

Every equipment and user interface within the Cresnet system requires a unique

identity code (Net ID). These codes are two-digit hexadecimal numbers from 03 to

FE. Refer to “Interface Menu” on page 8 for instructions on setting the unit’s Net ID.

The Net ID of the unit must match the Net ID specified in the SIMPL Windows

program. Refer to “Setting the Net ID in Device Settings” on page 12 for details of

the SIMPL Windows procedure.

Configuring the Touchpanel

Main Menu for CT-1550

NOTE: The only connection required to configure the touchpanel is power. Refer to

“Hardware Hookup” on page 8 for details.

It may be necessary to make adjustments or configure the touchpanel to accommodate

proper operation for the end user. This is accomplished through the Setup Mode.

Instructions for configuring the touchpanel are given in the following paragraphs.

The Main Menu, shown to the left of this paragraph, appears when a finger is held to

the touchscreen for about three seconds from the powered down state. This screen

indicates that you are in “setup mode” and can proceed to configure the touchpanel.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Sem comentários

Crestron CT-1550 Especificações Página 10