Crestron C2N-FTB Guia de Instalação descarregar pdf (Página 14)

FlipTop Control Center, Dual AC Outlets Crestron C2N-FTB-D

Button Installation

The C2N-FTB-D is shipped with ten large blank buttons. You can order a variety of

button kits (sold separately) for a total of 20 engraved or blank buttons.

Button Kits

KIT NUMBER DESCRIPTION

FT-BTNB-L One large button engraved as desired

FT-BTNB-L-BLANK One large button not engraved

FT-BTNB-S Two small buttons with divider engraved as desired

FT-BTNB-S-BLANK Two small buttons with divider, not engraved

To replace the supplied large blank buttons with large engraved buttons or small

buttons, follow this procedure.

A 1/16" Allen (hexhead) wrench is required to remove the button faceplate.

1. Remove the four Allen screws that secure the button faceplate.

2. While holding adjacent buttons in place, carefully pull the button(s) to be

replaced from the rubber membrane.

3. Carefully press the large replacement button or two small replacement buttons in

place, making sure LED window faces up. Use care not to dislodge the

membrane and circuit board.

NOTE: The removable buttons fit snugly on the rubber membrane. Remove

carefully to avoid pulling the membrane from the unit.

4. For small replacement buttons, the divider bar slips into the slots on the back of

the faceplate.

5. Replace the faceplate using the four Allen screws.

Button Installation

10 • FlipTop Control Center, Dual AC Outlets: C2N-FTB-D Operations & Installation Guide – DOC. 6639B

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

Sem comentários

Crestron C2N-FTB Guia de Instalação Página 14