Crestron CNRACKX-DP Especificações descarregar pdf (Página 9)

Crestron CNXENET+ CNX Enhanced Ethernet Expansion Card

9. As shown below, align the pins on the 26-pin DPA connector of the

CNXENET+ with the ETHERNET connector on control system

processor board.

CNMSX Installation (3 of 3)

26-PIN DPA

CONNECTOR

MOUNTING

BRACKETS

REAR PANEL

(REFERENCE ONLY)

NOTE: The DPA pins are more easily inserted by gently “rocking” the

CNXENET+ side-to-side while pressing onto DPA connector.

10. DO NOT force pins into connector and press CNXENET+ until pins

are fully seated. Make sure that the mounting brackets on CNXENET+

align with mounting holes of the control system. Make sure that the

LAN/DPA connector aligns with cut out.

11. From the control system rear panel, reinstall the two screws and

lock washers

to secure CNXENET+ . Tighten the screws to

finger-tight then, using a #1 Phillips tip screwdriver, tighten the screws

an additional 1/8-turn

12. Reposition the I/O printed circuit board

connectors into the rear

panel slots and reinstall six

screws to secure I/O printed circuit

board

. Tighten the screws to finger-tight then, using a #2 Phillips

tip screwdriver tighten the screws an additional 1/8-turn

13. Reinstall the control system top cover

with six screws on each

side and four

screws on top. Tighten the screws to finger-tight then,

tighten the screws an additional 1/8-turn.

Installation onto CNRACKX Processor Card

(CNXCPU)

The CNRACKX contains the CNXCPU Processor Card (the CNRACKX-DP

contains two CNXCPU’s) that features Crestron’s exclusive DPA (Direct Processor

Access) slot for Ethernet/LAN expansion of the control system. The CNXCPU

contains card mounting points, a LAN/DPA port opening, and a 26-pin female DPA

connector. The CNXENET+ is mounted to the faceplate of the CNXCPU and a

Operations & Installation Guide – DOC. 8153A CNX Enhanced Ethernet Expansion Card: CNXENET+ • 5

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Sem comentários

Crestron CNRACKX-DP Especificações Página 9