Crestron CNRACKX-DP Especificações descarregar pdf (Página 8)

CNX Enhanced Ethernet Expansion Card Crestron CNXENET+

CNMSX Installation (1 of 3)

REAR PANEL

(REFERENCE ONLY)

2. Remove six

screws from each side of the control system.

3. Lift and remove control system top cover

4. As shown below, remove six

screws that secure I/O printed circuit

board

to the control system.

CNMSX Installation (2 of 3)

REAR PANEL

(REFERENCE ONLY)

5. Slide the I/O printed circuit board

toward the front panel of the

control system so that the rear connectors are clear of the rear panel

slots and reposition the I/O printed circuit board

to gain access to the

LAN/DPA cover plate

6. Using a #1 Phillips tip screwdriver, remove two

screws and two

lock washers

that secure the LAN/DPA cover plate to the control

system rear panel.

7. From inside the control system, remove the LAN/DPA cover plate

8. For older model control systems, carefully push the computer interface

ribbon cable aside to make room for the CNXENET+. For newer

systems, make sure that cable does not interfere with CNXENET+

placement.

4 • CNX Enhanced Ethernet Expansion Card: CNXENET+ Operations & Installation Guide – DOC. 8153A

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Sem comentários

Crestron CNRACKX-DP Especificações Página 8