Crestron QM-MD8x8 Especificações descarregar pdf (Página 21)

Crestron QM-MD8x8 QuickMedia Distribution System

3. Secure the ear to the unit with three screws from step 1, as shown in the

following diagram.

Ear Attachment for Rack Mounting

USE COVER SCREWS

4. Repeat procedure (steps 1 through 3) to attach the remaining ear to the

opposite side.

Stacking

Four "feet" are provided with the MD8X8 so that if the unit is not rack mounted, the

rubber feet can provide stability when the unit is placed on a flat surface or stacked.

These feet should be attached prior to the hookup procedure. Refer to the illustration

below for placement of the feet.

Feet Location (Bottom View of Unit)

ATTACH FEET

NEAR CORNERS

OF THE UNIT

Hardware Hookup

Refer to the following hookup diagram and, aside from attaching power last,

complete the connections in any order. Refer to “Network Wiring” on page 10 when

making network connections.

NOTE: To prevent overheating, do not operate this product in an area that exceeds

the environmental temperature range listed in the table of specifications.

Consideration must be given if installed in a closed or multi-unit rack assembly since

the operating ambient temperature of the rack environment may be greater than the

room ambient. Contact with thermal insulating materials should be avoided on all

sides of the unit.

NOTE: The maximum continuous current from equipment under any external load

conditions shall not exceed a current limit that is suitable for the minimum wire

gauge used in interconnecting cables. The ratings on the connecting unit's supply

input should be considered to prevent overloading the wiring.

Operations Guide - DOC. 6260 QuickMedia Distribution System: QM-MD8x8 • 17

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 43 44

Sem comentários

Crestron QM-MD8x8 Especificações Página 21