Crestron CT-3000 Especificações descarregar pdf (Página 16)

Crestron e-control Database Manager SW-DBM

16 •• Server Configuration In Depth Installation & Reference Guide — DOC. 5823

Reply from 132.149.2.2: bytes=32 time=8ms TTL=60

Reply from 132.149.2.2: bytes=32 time=5ms TTL=60

Once a reliable connection is established, test that the CNX control system is

listening and responding properly. Reconfigure Viewport communications to use

TCP/IP by selecting Setup | Communications Settings. Once the Port Settings

window opens, select TCP/IP as the Connection Type. For IP Address, Click on

Fixed and enter the CNX control system IP address in the active field. Test the new

connection by issuing the Diagnostics | Check Operating System Version

command.

Additional Server Side Setup

In addition to properly setting up and testing communications with each connected

system, the following steps are also required to make the server operational:

1. Select database file. Supply the full pathname to the database under the

COM Settings tab. This file is the sole source of all database tables accessed

by all signal blocks. See “The Database File,” page 32, for additional

information.

The demos are pre-configured to point to the file DBMdemo.mdb in the demos

folder.

2. Indicate control system connection. Point each active signal block to a COM

Settings definition. (If you have not yet defined the connection through which

this signal block will communicate, you can leave this blank for the now.

However, the signal block cannot be activated until it references a COM

Settings definition.) See “COM Settings,” page 23, for a description of how to

point a signal block to a COM Settings definition.

All the signal blocks in the demo configuration already point to a COM Settings

definition.

Server Configuration In Depth

This section is a reference to all the options available in the Configuration Options

window. Changes to options in this window are saved to the current Configuration

Settings file when the OK or the Apply buttons are actuated. Therefore, it is

important to make sure you are operating on the appropriate Configuration Settings

file before opening the window.

Specifying a Configuration File

The installer registers the file demoDBM.ini as the current Configuration

Settings file. This file pre-configures the server for all three demos, and particularly

for use with the Quick Start Guide — which instructs you to load demo1.

You can use the File | Configuration file… command to select a Configuration

Settings file of your choice. The file pathname so specified is stored in the Windows

registry on your machine. In addition to specifying the configuration filename, this

command also instantly reconfigures the server based on the named file. This is a

very useful feature for the developer working on multiple projects.

NOTE: If the server cannot open a specified configuration file, it uses default values for all options.

If any changes are made, a new config file is created using the specified pathname when the OK or

the Apply buttons are actuated

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 93 94

Comentários a estes Manuais

Sem comentários

Crestron CT-3000 Especificações Página 16

Comentários a estes Manuais