Crestron C2N-SDC Guia de Instalação descarregar pdf (Página 2)

Product warranty can be found at www.crestron.com/warranty.

The specific patents that cover Crestron products are listed at patents.crestron.com.

Crestron, the Crestron logo, Cresnet, and Crestron Toolbox are either trademarks or registered

trademarks of Crestron Electronics, Inc. in the United States and/or other countries. Other trademarks,

registered trademarks, and trade names may be used in this document to refer to either the entities

claiming the marks and names or their products. Crestron disclaims any proprietary interest in the

marks and names of others. Crestron is not responsible for errors in typography or photography.

This document was written by the Technical Publications department at Crestron.

HARDWARE HOOKUP

Connections for power, Cresnet, and shades or drapes must be made prior to installation.

Power Hookup

AC power is connected to the three pigtail leads as shown in the following illustration.

AC Hookup Connections for the C2N-SDC

TROUBLESHOOTING

The following table provides corrective action for possible trouble situations. If further

assistance is required, please contact a Crestron customer service representative.

C2N-SDC Troubleshooting

OPERATION

The C2N-SDC front panel can be used for local control and Net ID setup. Refer to the

following illustration for details.

C2N-SDC Operation

NOTE: All wiring must be installed in accordance with all local and national electrical

codes.

Shade or Drape Motor Hookup

Pass the shade or drape motor cable through the nylon cable clamp (supplied, refer to

“Installation”) and through the hole in the front of the C2N-SDC. Connect the shade or

drape motor cable as shown in the following illustration.

C2N-SDC Connections

NOTE: The power wires are not shown in this illustration for clarity.

Common (Neutral)

Ground

Down

Motor Cable

Ground - Green with Yellow Stripe

Hot - Black

3-Wire AC Pigtail Wire Colors

Neutral - White

The 3-wire ac pigtail

exits from the back of

the C2N-SDC.

Cable secures the

pigtail to the rear of the

C2N-SSDC.

AC Wiring to Breaker

Motor

Controls 1

Motor

Controls 2

Grommet

Holes for

Motor Control

Cables

Power Indicator LED

(Indicates power received

from Cresnet)

NET Indicator LED

(Indicates unit identified

in program)

Cresnet

Connectors

SETUP LED and Push

Button to Set Net ID

Using Crestron Toolbox

TROUBLE POSSIBLE CAUSE(S) CORRECTIVE ACTION

The green PWR LED

does not illuminate.

An incorrect power

supply is being used.

Use a Crestron power

supply.

The device is not

receiving power.

Verify that the cables

plugged into the NET ports

are secure.

The yellow NET LED

does not illuminate.

There is an improper

Net ID on the device or

program.

Verify that the C2N-SDC’s

Net ID matches the Net ID in

the control system program.

There is a loose

network connection.

Verify that the cable plugged

into the NET port is secure.

The shade or drape

does not respond.

A fault exists in the ac

wiring.

Check the wiring.

A fault exists with the

shade or drape.

Verify that the shade or drape

upper and lower limits are set

properly. Refer to the shade

or drape manufacturer's

instructions.

1 2

Comentários a estes Manuais

Sem comentários

Crestron C2N-SDC Guia de Instalação Página 2

Comentários a estes Manuais

Manuais e produtos relacionados com não Crestron C2N-SDC