Crestron 1700C-BTNS-BEZELS Guia de Instalação descarregar pdf (Página 7)

Crestron 1700C-BTNS/BTNB-BEZELS Button Bezel Kits

Installation

Perform the following to remove the existing bezel and install the

pushbuttons, new bezel, and supporting parts onto the 1700 Series

touchpanel. A #1 Phillips screwdriver is required. Refer to the

illustrations that accompany the procedure.

1. Remove power from the touchpanel (either disconnect the

power pack, remove the battery, or disconnect the RJ-11

Cresnet connection, depending on the touchpanel model) and

place the touchpanel face down on a clean padded work

surface.

2. Remove the four screws that secure the front bezel to the base

and return the unit to its normal position. (Use care and hold the

bezel to the rest of the panel. If the bezel separates from the

base while rotating the unit to its normal position, the internal

parts of the panel may spill out.)

Bottom View Showing Screw Locations

ScrewScrew

3. When in the normal position, lift the bezel from the touchpanel.

4. Cover each membrane switch actuator with pushbuttons.

Observe that pushbuttons differ from each other by their curved

arrangement to match the openings in the bezel as well as the

markings on the back. Pushbuttons marked 1 – 5 should be

installed to the left of the touchpanel screen while pushbuttons

marked 6 – 10 should be positioned to the right of the screen.

(Each button’s marking includes ‘TOP’ to ensure proper

orientation.)

CAUTION: DO NOT cut or separate individual pushbuttons from the

left and right pushbutton assemblies. Doing so will impair their use.

Operations & Installation Guide - DOC. 6321A Button Bezel Kits: 1700C-BTNS/BTNB-BEZELS • 3

1 2 3 4 5 6 7 8 9 10 11 12

Sem comentários

Crestron 1700C-BTNS-BEZELS Guia de Instalação Página 7