
quickstart guide
TPMC-3X Series
www.crestron.com
888.273.7876 201.767.3400
Specifications subject to
change without notice.
TPMC-3X Series
Isys
®
2.8” Handheld WiFi Touch Screens
To charge its internal battery pack, the TPMC-3X Series touch
screen must be placed on the included docking station/charger.
Connect the included power pack to the docking station/charger.
1
Power
NOTE: During regular operation of the touch screen, there are
three ways to activate the setup functions:
For Regulatory Compliance information, refer to the latest
version of Doc. 7409.
QUICKSTART DOC. 6790C (2023713, Sheet 1 of 2) 07.12
The setup screen is the starting point for configuring a TPMC-3X
Series touch screen. When power is applied for the first time, the
following screen appears.
1
NOTE: Before using the TPMC-3X Series touch screen for the
first time, charge its internal battery pack for at least two hours
by placing it on the included docking station/charger.
It takes the TPMC-3X Series touch screen about 2 hours to
recharge while in use. A fully charged battery can provide up
to 5 hours of use at the full screen brightness setting.
NOTE: When not using the TPMC-3X Series touch screen,
store the unit on its docking station/charger.
NOTE: The TPMC-3X Series touch screen can become
unresponsive when battery strength is low.
2
Configure the Touch Screen
Touch the screen to display the TPMC-3X Series setup screen,
as shown in the illustration to the right. The setup screen enables
basic configuration procedures prior to regular operation of the
touch screen.
System Bar
1. Place a button on the project main page and assign the
reserved join number (17242) that activates setup.
2. Press hard keys 1, 2, 3, and 4 in sequence twice (i.e. press
1, 2, 3, 4, 1, 2, 3, 4) within a 5 second period.
3. If the system bar is visible at the top of the display, access
the setup screen by touching the Crestron swirl logo in the
upper left corner.
4
3 2 1
GUIDE HOME LIST
Comentários a estes Manuais