Crestron CHV-RSS Guia de Instalação descarregar pdf (Página 12)

Remote Slab & Outdoor Temperature Sensor Crestron CHV-RSS

•

Remote Slab/Outdoor Temperature Sensor: CHV-RSS Installation Guide – DOC. 6229D

Hardware Hookup

CHV-RSS sensors connect to the terminal blocks on the back plate of the

CHV-TSTAT, CHV-THSTAT, CHV-TSTATEX, CHV-TSTATEX-FCU

thermostats (all sold separately).

NOTE: Sensor wiring is non-polarized.

NOTE: Up to two CHV-RSS sensors may be connected to a single

channel.

NOTE: Use a separate run of wire for each sensor.

NOTE: Wire runs should be low capacitance twisted pair wire such as

CAT3 (up to 250 feet (76 meters)), CAT5 (up to 500 feet (152 meters)),

or similar low capacitance (less than 7000 pF) wire.

NOTE: Sensor lines should not be run parallel to any other wiring. Lines

should cross other cables at right angles.

Complete the following procedure to connect the CHV-RSS to the

system:

1. Turn off the circuit breaker.

CAUTION: Do not press on the LCD display of the thermostat

during this procedure, as this may cause the screen to crack.

2. Separate thermostat front plate from back plate (it may be

necessary to exert force when removing the faceplate.)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Sem comentários

Crestron CHV-RSS Guia de Instalação Página 12