Crestron SW-WMC Manual do Utilizador descarregar pdf (Página 9)

Bug Fixes

Various fixes for Network Setup wizard related to:

"Upload type not supported" message seen in upload

dialog.

Crash when launching upload dialog in

SystemBuilder

Getting stuck at "Connecting..." to PMC3-XPs

Several fixes related to multiple programs on the

MC3

Fixed crash when going from Prodigy Composer to

SystemBuilder in some cases

Fixed timeout during firmware upgrades to newer Digital

Media devices.

Fixed DM Tool lockup when connecting to a 6x1 switcher

Toolbox 2.25.061 (2-11-2011)

Bug Fixes

Many fixes in DM Tool for various device specific issues.

SVideo not shown on Input page of TX-200-2G

RMC-200-C - DM Tool Output Setup Video Controls

don't respond when video is 3D

TX-100 Incoming stream does not show 3D

information if the source is 3D

No Audio Reported on RGBHV input page for Analog

Audio In: TX-200-2G

RMC-200-C - Output User Resolutions disappear in

list in DM Tool

Changing key count manually causes incorrect save

dialog to pop up

DMC-CAT: In DMTool show signal info connector even

if no DM device detected

Add displaying the TCP/IP config on all "switches"

Input Compensation Wording on DVI card is

incorrect, says SPDIF

DMC-CO-HD Card - Deep Color setup issues

Input Settings Signal Type /Decoding Mode is

missing entries for DD 5.1 and DTS 5.1

EDID Copy Display on output 2 not working for TX-

300N-F Inputs

When or VGA is plugged into TX-300, must block

EDID write until after cable removal

Fixed bug which was causing issues changing Cresnet IDs

using the following method.

Assuming you have three cresnet devices with the

same ID. Plug in the first one, use Network Device

6/1/2011 Crestron Toolbox: Crestron Toolbox Rele…

crestron.com/…/toolbox_2_26.html 9/147

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 146 147

Comentários a estes Manuais

Sem comentários

Crestron SW-WMC Manual do Utilizador Página 9

Comentários a estes Manuais

Manuais e produtos relacionados com Software Crestron SW-WMC