Crestron SW-SIMPL Manual do Utilizador descarregar pdf (Página 33)

Sequences

It is possible to trigger multiple actions with only one button press.

Actions like this are used to start up or shut down a complete

room/installation: lights go to the right level, projector switches goes

on, screen comes down, switcher changes to the right

input/output,… all activated by only one button press.

Useful Symbols:

The Stepper symbol

drives its output signals high on the rising edge of <trig>

after the cor

responding <delay> expires. Each output then remains high for the

period specified by its cor

responding <len> parameter. Any subsequent changes

in <trig> have no effect until all outputs are low again.

The <busy> output goes high if any outputs are high, and low when all outputs are

low.

The Delay symbol

drives each output to the level of the <trig> input after the

corresponding <delay> expires. Note that all specified delays are independent of

one another; that is, there is no cumulative delay effect.

The optional <reset> immediately drives all outputs to the level of <trig> (with no

delay) for as long as <reset> is high.

By using an OR symbol

you can trigger a function with multiple driving sources

1 2 ... 28 29 30 31 32 33 34 35 36 37

Sem comentários

Crestron SW-SIMPL Manual do Utilizador Página 33