Crestron SP-1 Especificações descarregar pdf (Página 18)

CRESTRON

14 •• SmartPresenter™: SP-1 Operations Guide - DOC. 5712

NOTE: Crestron recommends that the “linked” device be either a video projector

or switcher.

For example, if a VCR (assigned to button 1) is required to select the Video1 input

on a projector (assigned to button 4), it is necessary to link device 1 to device 4 to

make the macro function automatically.

1. Assign a valid Q-Code to output device 4.

2. Verify by selecting device 4 and pressing the device control buttons,

until the correct image is displayed. Make a notation for each device

needed to link. The information is required to successfully complete

this procedure.

Device Control Buttons (A Through F) on Transmitter

3. Depress (with a blunt object e.g., paper clip) the recessed device

assignment button 4 on the SP-1.

Observe flashing red device output #4 LED.

4. Depress the SP-1 recessed device assignment button (numbered 1, 2,

or 3) associated with a device to be “linked”.

Observe two flashing red device output LEDs (4 and the LED for the

device to be “linked”).

5. Per the information gathered in step 2, select a function for the device

assigned to output 4 by depressing a device control button on the

transmitter.

Observe that the two flashing device output LEDs extinguish and the

red RF LED illuminates for approximately five seconds.

6. Repeat steps 3 through 5 for the other two device outputs on the SP-1,

if applicable.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Sem comentários

Crestron SP-1 Especificações Página 18