Crestron TPS-ENET Guia de Instalação descarregar pdf (Página 17)

Crestron TPS-ENET Ethernet Card for TPS/Tilt Panel

Accessing the Viewport

4. Refer to the documentation supplied with the host control

system and verify communication.

5. As shown below, select Remote | Remote Console | Connect

from the menu.

Viewport Remote Console Connect

6. From the window, select the appropriate NET ID of the

touchpanel.

7. Observe the Viewport connect to the touchpanel.

Ethernet Setup

Ethernet configuration is only performed via the touchpanel console and

not available through Viewport setup screens. This section contains the

console commands required to setup the TPS touchpanel(s) for Ethernet

operation. To setup the touchpanel for Ethernet operation, perform an

appropriate section of “Obtaining Communication” on page 9 then enter

the desired commands. An example Ethernet setup is described on page

14. When in remote console mode, Viewport will display <TPS at the

command prompt.

Operations & Installation Guide - DOC. 6016 Ethernet Card for TPS/Tilt Panel: TPS-ENET • 13

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Sem comentários

Crestron TPS-ENET Guia de Instalação Página 17