Crestron CP2 Especificações descarregar pdf (Página 33)

Crestron CP2/CP2E 2-Series Integrated Control Processor

Battery Replacement

A Lithium battery is used to power the system clock within the CP2/CP2E. Under

normal conditions, it will last for approximately 10 years. In the event that the clock

fails, only an authorized technician should replace it. Refer to caution statement

below.

CAUTION: Danger of explosion if battery is incorrectly replaced.

Replace only with the same or equivalent type recommended by the manufacturer.

Dispose of used batteries according to the manufacturer's instructions.

Passthrough Mode

Passthrough Mode enables Viewport access to any serially controlled device on the

network. That is, it allows direct communication between the PC and a network

device (effectively "passing through" the CP2 or CP2E). While Passthrough mode is

running, the program currently in memory is suspended and will not execute. When

Passthrough mode is exited, the program resumes operation. The TX and RX LEDs

for the given port illuminate when in Passthrough mode.

Entering Passthrough mode for one of the internal COM ports reinitializes it, which

clears the data for that port.

To establish communication, click Functions | Enter Passthrough Mode. Then

select the connection type that exists between the CP2/CP2E and the device. The

choices are Slot (for devices connected to the control system via one of the card slots

on the back panel), Cresnet, or Ethernet. If the connection is through a card slot then

select the slot number from the Slot drop-down list. For Cresnet, select the Cresnet

ID of the device; for Ethernet, the IP ID.

NOTE: The IP ID and associated IP address of the Ethernet device must be listed in

the IP Table.

Specify the port (Port A through Port F) that the device is connected to, if applicable.

Next, specify the serial protocol that the device expects. The parameters include the

baud rate, parity, the number of data bits and stop bits, the protocol (RS-232, RS-422

or RS-485), and the settings for software or hardware handshaking. This information

is provided by the manufacturer’s documentation.

Operations Guide - DOC. 5980 2-Series Integrated Control Processor: CP2/CP2E• 29

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 39 40

Comentários a estes Manuais

Sem comentários

Dimplex DWF36 Instrukcja Obsługi (14 strony)

Marka: Dimplex | Kategoria: Fireplaces | Rozmiar: 1.41 MB |

Spis treści

Service Manual

TABLE OF CONTENTS

OPERATION

MAINTENANCE

EXPLODED PARTS DIAGRAM

REPLACEMENT PARTS LIST

WIRING DIAGRAM

HEATER ASSEMBLY REPLACEMENT

FLICKER MOTOR REPLACEMENT

LED LIGHT HARNESS REPLACEMENT

ON/OFF SWITCH REPLACEMENT

REMOTE SWITCHBOARD

REPLACEMENT

CIRCUIT BOARD REPLACEMENT

TROUBLESHOOTING GUIDE

PROBLEM CAUSE SOLUTION

Więcej produktów i instrukcji dla Kominki Dimplex

Modele	Rodzaj dokumentu
BLF34	Instrukcja Właściciela Dimplex BLF34 Owner`s manual, 22 strony
BFSL33	Instrukcja Obsługi Dimplex BFSL33 Service manual, 19 strony
CFA36BS	Instrukcja Użytkownika Manual del propietario, 14 strony
V1525RT	Instrukcja Właściciela Dimplex V1525RT Owner`s manual, 20 strony
RWF-DG	Instrukcja Właściciela Dimplex RWF-DG Owner`s manual, 11 strony
LVA232	Instrukcje Operacyjne Dimplex LVA232 Operating instructions, 24 strony
DFI600LH	Instrukcja Obsługi Dimplex DFI600LH Service manual, 10 strony
BF39STP/DXP	Instrukcja Użytkownika Electric Fireplaces, 8 strony
DF2307SS	Instrukcja Obsługi Dimplex DF2307SS Service manual, 11 strony
RTOPW20	Instrukcje Operacyjne Dimplex RTOPW20 Operating instructions, 12 strony
Optiflame Electric Fireplace	Podręcznik Użytkownika Dimplex Optiflame Electric Fireplace User`s guide, 10 strony
Presada PRS20	Instrukcje Operacyjne Dimplex Presada PRS20 Operating instructions, 16 strony
WBK20	Instrukcje Operacyjne Dimplex WBK20 Operating instructions, 32 strony
DF2624L	Instrukcja Obsługi Dimplex DF2624L Service manual, 12 strony
ALBANY ABN 15	Instrukcje Operacyjne Dimplex ALBANY ABN 15 Operating instructions [en] , 9 strony
DFP15-1132	Instrukcja Obsługi Dimplex DFP15-1132 Service manual, 11 strony
Obsidian OBS20	Instrukcje Operacyjne Dimplex Obsidian OBS20 Operating instructions, 24 strony
Silverton SVT20	Instrukcje Operacyjne Dimplex Silverton SVT20 Operating instructions, 20 strony
VCX1525	Instrukcja Właściciela Dimplex VCX1525 Owner`s manual, 20 strony
WBK20	Instrukcje Operacyjne Dimplex WBK20 Operating instructions, 13 strony