Crestron TPMC-10-DSW Manual do Utilizador descarregar pdf (Página 10)

Mud Mount Kits Crestron MMK-8X-DSW & WMKM-8X-DSW

Create the Adjustment/Mounting Plate Assembly

PUSH-ON FASTENER (4)

(2004121)

MOUNTING PLATE

(2017789)

ADJUSTMENT PLATE (2)

(2004825)

2. Slide a push-on fastener over each pin on the adjustment plate to loosely

secure the adjustment plate and the mounting plate. Do not push the

push-on fasteners all the way down onto the pins. Slide them on enough to

keep the adjustment plate and mounting plate as one adjustment/mounting

plate assembly.

3. Use the second adjustment plate and repeat steps 1 and 2 using the lower

two pins.

4. Locate an area on the wall that is free of miscellaneous wiring and studs.

5. Make a small hole near the middle of the designated site; verify that the

location is suitable.

NOTE: Make the cutout as level as possible. The mounting plate allows for only

minor leveling adjustments.

6. Use the drywall saw or equivalent to produce a level, rectangular cutout in

the drywall as shown on page 3.

7. Insert the symmetrical mud ring plate into the opening, as shown in the

illustration on the following page.

8 • Mud Mount Kits: MMK-8X-DSW & WMKM-8X-DSW Installation Guide – DOC. 6581B

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Sem comentários

Crestron TPMC-10-DSW Manual do Utilizador Página 10