
Wall Mount Docking Station for TPS-6X Crestron TPS-6X-DSW
Connectors, Controls & Indicators
#
CONNECTORS
1
,
CONTROLS &
INDICATORS
DESCRIPTION
1
TOUCHPANEL
CONNECTOR
(1) 10-pin connector for attaching touchpanel
2 LATCH RELEASE Manual latch release
3 OPEN
(1) Miniature pushbutton, accessible when
touchpanel is not docked, releases the
docking mechanism to allow touchpanel to
be docked
4
NET
(1) 4-pin 3.5 mm detachable terminal block;
Cresnet slave port, connects to Cresnet
control network
24: Power (24 Volts DC)
Y: Data
Z: Data
G: Ground
5
VID IN (UNBL)
2
S
V
(1) 2-pin 3.5 mm detachable terminal block;
Unbalanced composite video input;
Input impedance: 75 Ω nominal;
Input level: 1 V
p-p
nominal, 1.5 V
p-p
maximum;
Maximum DC offset: ±2 Volts;
Connects to any conventional coax video
source
6
VID IN (BAL)
2
S
-
+
(1) 3-pin 3.5 mm detachable terminal block;
Balanced composite video input;
Input impedance: 100 Ω nominal;
Input level: 1 V
p-p
nominal, 1.5 V
p-p
maximum;
Maximum DC offset: ±2 Volts;
Connects to any Crestron CH CAT5 Video
Out port via CresCAT
®
cable
7
LAN
3
Pin 1
(1) 8-wire RJ-45 female;
10 BASE-T/100BASE-TX Ethernet Port
PIN SIGNAL PIN SIGNAL
1 TX + 5 N/C
2 TX - 6 RX -
3 RX+ 7 N/C
4 N/C 8 N/C
1. Interface connectors for NET, VID IN (BAL), and VID IN (UNBL) ports are provided with the unit.
2. Balanced and unbalanced video inputs are mutually exclusive.
3. To determine which is pin 1 on the cable, hold the cable so that the end of the eight pin modular plug
is facing away from you, with the clip down and copper side up. Pin 1 is on the far left.
6 • Wall Mount Docking Station for TPS-6X: TPS-6X-DSW Operations & Installation Guide – DOC. 6708B
Comentários a estes Manuais