Crestron CLS-C6 Especificações descarregar pdf (Página 5)

iLux Dimmer Expansion Module Crestron CLS-EXP-DIMFLV

Installation Guide – DOC. 6680B iLux 0-10V Fluorescent Dimmer Expansion Module: CLS-EXP-DIMFLV

•

Connectors and Indicators (Continued)

# CONNECTORS

AND

INDICATORS

DESCRIPTION

3 INPUT–CTRL

(1) Captive screw terminal,

control input from

CLS(I)-C6 Series,

CLW-DIM Series,

CLX(I)-DIM Series,

GLX-DIM6, GLXX-2DIM8,

DIN-1DIM4, or

DIN-1DIMU4 dimmers

NOTE: Presents a 25 watt

load to the controlling

dimmer; a maximum of five

CLS-EXP-DIMFLV modules

may be connected to the

controlling dimmer, which

cannot be wired to control

any other loads besides the

CLS-EXP-DIMFLV

modules.

4 INPUT–NEUT

(1) Captive screw terminal,

neutral connection for

control input

5 OUTPUT–SW OUT

(1) Captive screw terminal,

switched load output

6 OUTPUT–HOT

(1) Captive screw terminal,

line power input

7 OUTPUT–NEUT

(1) Captive screw terminal,

neutral connection for line

power input and load

8 0-10V–(+)

(1) Captive screw terminal,

dimming control output;

Class 1 or Class 2 wiring

allowed;

Control Voltage: 0-10 Vdc,

70 mA

9 0-10V–(-)

(1) Captive screw terminal,

dimming control output;

Class 1 or Class 2 wiring

allowed;

Control Voltage: 0-10 Vdc,

70 mA

10 GROUND

(1) 3-terminal chassis

ground bus bar

1. Captive screw terminals accept up to two 22 to 12 AWG (0.34 to

4 mm

) wires per terminal.

2. CLW-Series device must have a dedicated neutral.

Setup

Important Notes

Read before installation.

• Install in accordance with all local and national

electrical codes.

• Use 75°C copper wire only.

Installation

Refer to the following diagram when installing a

CLS-EXP-DIMFLV module.

Module Installation

NOTE: To prevent potential heat damage to the drywall,

do not mount the CLS-EXP-DIMFLV directly onto

drywall. Mount a piece of 1/2 in (13 mm) minimum thick

plywood between the CLS-EXP-DIMFLV and the

drywall.

NOTE: To ensure proper ventilation, the device must be

installed vertically on a vertical surface. Install device

with 6 inches (153 mm) of clearance from the top and

bottom of the device.

Mounting Surface

CLS-EXP-DIMFLV

Mounting Screw, #8

Qty. 4 Total

(Not Supplied)

1 2 3 4 5 6 7 8

Comentários a estes Manuais

Sem comentários

Crestron CLS-C6 Especificações Página 5

Comentários a estes Manuais

Manuais e produtos relacionados com Interruptores com regulação Crestron CLS-C6